The equipment for universatile use in the renovation and water proofing is the screw pump BMP 6. This pump is an allround equipment for filling,
injecting or spraying a wide range or products with a grain size up to 2,0 mm such as mineral grouts, bituminous water proofing, fine plasters and renders, joint mortars,
paints and also bituminous thick coatings and epoxy mortars.
Solvent-containing products should only be used after consultation with the manufacturer. For filling and injection only electric power supply
of 230 or 110 V is needed. If spray application is required and additional air compressor for the atomizing air is necessary with an air output between 150 ltr
(fine products) up to 400 ltr (bituminous thick coatings) per min. A selection of accessories is available for the injection
with almost any crack injector on the market. Material transport and pressure is created by a rotor inside a stator. The
output capacity is steplessly adjustable between 0,5 up to 14 ltr / min. Remote control cables in different versions are available.

Consisting of:
Screw pump BMP 6 240 V
Material hose 3/4″ x 10 mtr. GEKA
Air hose 3/8″ x 11 Mtr.
Spray lance set with 5 nozzles
ATTENTION: Without compressor