If larger flow rates are required, the BMP 7 screw pump is the right choice. This appliance is ideal for processing all mineral products with a grain size of up to 3.0 mm by injection or spraying (borehole suspensions, Sealing slurries, fine plasters, grouting mortar, anchor mortar, thick coatings, concrete replacement compounds)

Solvent-containing products should only be used after consultation with the manufacturer.
For filling and injection only electric power supply of 230 or 110 V is needed.
If spray application is required and additional air compressor for the atomizing air is necessary with an air output between 150 ltr (fine products) up to 500 ltr (thick coating) required.
With an wide range of accesiores it is possible to work with almost any available packer system for mineral products.
Material transport and pressure is created by a rotor inside a stator. The output capacity is steplessly adjustable between 2 up to 20 ltr / min. Remote control cables in different versions are available.

2-speed gearbox, easy to dismantle into 3 parts Connection: mortar coupling V25, 230V-50Hz, optional 110V available

Light & Strong: For pumpable materials up to 3 mm grain size
Optionally available:
+ Remote controls
+ Automatic lances
+ mixer DZ 60
Note: An additional compressor is required for spray application.
Air discharge volume depending on material 200 – 500 ltr. / min.
Note: Diameter of material hoses and nozzles and air requirement
are always dependent on the material used.